|
The removal
of the polyimide coating in order to provide a UV transparent
window is often a source of inaccuracy in CE experiments.
For convenient
and reproducable preparation of UV transparent windows in polyimide
covered capillaries, EKT have developed an easy to use capillary
burner device. The capillary is simply pushed through the guide
holes until it reaches the correct position for the window as
chosen by the user and the simple push of a button initiates a
controlled heating of the capillary making a small, precise and
highly reproducable window.
- Precise
and Reproducable
- Easy to
Use
- Produces
Clean Finish
- Saves Time
and Money
- Long Life
Filament
The EKT burner
uses a special oxidation resistant nichrom wire filament which
can be used for the prepartion of many hundreds of capillaries
before it requires replacing. In addition to our standard filaments
which produce a 2mm length window, we also produce 1mm and 3mm
filaments. Low cost replacement filaments are available in all
three sizes.
The diagram
below shows a close up of the capillary in the filament holder
ready. The capillary is easily inserted into the device via accurately
positioned guide holes.

Burner
Filaments
The
EKT Capillary Burner is delivered fitted with a standard burner
filament which produces a detection window with an approximate
length of 2mm.
This standard
filament can be removed and replaced with a filament producing
a longer or shorter window in accordance with the analyst's requirements.
Burner filaments
are available in three different coil lengths: 1mm, 2mm and 3mm.
The diagram
below shows an example of four different windows created using
the standard 2mm burner coil on a 50um i.d. 375um o.d. capillary.
The high degree of reproducability of windows produced using the
EKT burner is clearly evident. (Test carried out by an independent
laboratory)

|